Patton-electronic 1008 Manual do Utilizador

USERMANUALMODEL 1008Ultra-Miniature, High Speed,Multipoint DB-9 Short RangeModemSALES OFFICE(301) 975-1000TECHNICAL SUPPORT(301) 975-1007http://www.pa

3.2 TYPICAL APPLICATIONS The Model 1008 is commonly used in five types of applications:4-wire/full duplex/point-to-point, 4-wire/half duplex/point-to

3.1.3 DIP SWITCH S2 SETTINGSDIP switch S2 is used to configure carrier control, RTS/CTS delayand communication protocol. The summary table below sho

7. When you finish connecting the wires to the terminal block, theassembly should resemble the diagram below:8. Place the 2 halves of the strain reli

To access the Model 1008’s internal PC boards, insert a small flat-blade screwdriver between the connector and the lip of the case andtwist gently as

3.0 CONFIGURATIONThe Model 1008 is configured using two PC board mounted4-position DIP switches. This section shows how to access the DIPswitches, p

2.0 GENERAL INFORMATIONThank you for your purchase of this Patton Electronics product.This product has been thoroughly inspected and tested and iswar

1.3 SERVICEAll warranty and non-warranty repairs must be returned freightprepaid and insured to Patton Electronics. All returns must have aReturn Mat

1.0 WARRANTY INFORMATION Patton Electronics warrants all Model 1008 components to befree from defects, and will—at our option—repair or replace the p

terminal raises DTR; DCD turns “ON” after recognizing the receive signal from the line; CTS turns “ON” after the terminal raises RTS.RTS/CTS Delay: 8

terminal raises DTR; DCD turns “ON” after recognizing the receive signal from the line; CTS turns “ON” after the terminal raises RTS.RTS/CTS Delay: 8

1.0 WARRANTY INFORMATION Patton Electronics warrants all Model 1008 components to befree from defects, and will—at our option—repair or replace the p

USERMANUALMODEL 1008Ultra-Miniature, High Speed,Multipoint DB-9 Short RangeModemSALES OFFICE(301) 975-1000TECHNICAL SUPPORT(301) 975-1007http://www.pa

1.3 SERVICEAll warranty and non-warranty repairs must be returned freightprepaid and insured to Patton Electronics. All returns must have aReturn Mat

2.0 GENERAL INFORMATIONThank you for your purchase of this Patton Electronics product.This product has been thoroughly inspected and tested and iswar

3.0 CONFIGURATIONThe Model 1008 is configured using two PC board mounted4-position DIP switches. This section shows how to access the DIPswitches, p

To access the Model 1008’s internal PC boards, insert a small flat-blade screwdriver between the connector and the lip of the case andtwist gently as

7. When you finish connecting the wires to the terminal block, theassembly should resemble the diagram below:8. Place the 2 halves of the strain reli

3.1.3 DIP SWITCH S2 SETTINGSDIP switch S2 is used to configure carrier control, RTS/CTS delayand communication protocol. The summary table below sho

3.2 TYPICAL APPLICATIONS The Model 1008 is commonly used in five types of applications:4-wire/full duplex/point-to-point, 4-wire/half duplex/point-to