Patton-electronic 1069 Manual do Utilizador

USER MANUALMODEL 1069OnSite™ VDSL2 CPEREGULATORY MODEL NUMBER: 03342D4-001SALES OFFICE(301) 975-1000TECHNICAL SUPPORT(301) 975-1007Part# 07M1069-UMRev

103.1 CONNECTING THE LINE INTERFACEThe Model 1069 supports communication over a distance of up to 10,000 ft (3 km) over 24 AWG (0.5 mm) twisted-pair

113.2 CONNECTING THE 10/100BASE-T ETHERNET INTERFACEThe RJ-45 ports labeled Ethernet are the Auto-MDIX10/100Base-T inter-faces. These ports are desi

123.4 CONNECTING POWERThe Model 1069 does not have a power switch, so it powers up as soon as it is plugged in.An external AC or DC power supply is a

134.0 CONFIGURATIONYou may use the DIP switch included in the Model 1069 for configuring the CO or CPE mode. All other configurations for the Model 1

145.0 OPERATIONOnce the Model 1069 is properly installed, it should operate transpar-ently. No user settings required. This section describes reading

15APPENDIX ASPECIFICATIONSA.1 VDSL2• Full compliance up to 30Mhz profileA.2 LAN CONNECTION• Four RJ-45, 10/100Base-T, IEEE 802.3 EthernetA.3 TRANSM

16APPENDIX BMODEL 1069 SERIES FACTORY REPLACEMENT PARTS AND ACCESSORIESPatton Model # DescriptionBase Models1069/EUI OnSite VDSL2 CPERJ45 Line, 100-24

17APPENDIX CMODEL 1069 SERIES INTERFACE PIN ASSIGNMENTC.1 10/100BASE-T INTERFACERJ-45• Pin 1: TX+• Pin 2: TX-• Pin 3: RX+• Pin 6: RX-• Pins 4, 5, 7,

18NOTES_______________________________________________________________________________________________________________________________________________

19NOTES_______________________________________________________________________________________________________________________________________________

2CONTENTS1.0 Warranty Information ... 31.1 Regulatory Information ...

20NOTES_______________________________________________________________________________________________________________________________________________

31.0 WARRANTY INFORMATIONPatton Electronics warrants all Model 1069 components to be free from defects, and will—at our option—repair or replace the

4tion. The device has been tested and found to comply with the limits for a Class A computing device in accordance with specifications in Subpart B of

51.6 SAFETY WHEN WORKING WITH ELECTRICITY• This device contains no user serviceable parts. This device can only be repaired by qualified service per

6In accordance with the requirements of council direc-tive 2002/96/EC on Waste of Electrical and Electronic Equipment (WEEE), ensure that at end-of-li

72.0 GENERAL INFORMATIONThank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected and tested and is

8Figure 1. Model 1069 rear panel 2.3 APPLICATIONIn an example application, the VDSL2 CPE modem is placed in either MxU environments or individual res

93.0 INSTALLATIONTo connect the Model 1069, do the following: 1. Connect the Line port of the Model 1069 with a telephone cable (refer to section 3